Laser Cut plate carrier made of Cordura laminate.
Low profile construction, also suitable as a base plate carrier.
Skeletor cummerbund
MOLLE velcro surface for equipment and badges
ROC quick release on the cummerbund
ROC quick release buckle on the shoulder strap
Including laser cut MOLLE flap on the rear plate ash
Handle on the rear plate pocket
Made in Germany

Material	Cordura® polyamide 6.6
Volume (litres)	0.0
Country of origin	DE

The plate carrier Vulcan LC (Lasercut) Skeletor is a convertible system that distinguishes itself through its low profile design and can be used as a pull-over and under-plate carrier. Equipped with ROC buckles (Rapid Opening Connector) on the cummerbund and shoulder straps, the plate carrier can be put on and taken off quickly. The plate pockets hold ballistic protective inserts measuring 25cm x 30cm. The hard ballistics and soft ballistics are fixed to the inside of the plate ash with Velcro. On the inside there are Velcro surfaces for additional padding.

The front has a combined Velcro Molle area at chest height for equipment and patches or badges. There is also a Velcro area on the back. The scope of delivery includes a MOLLE laser cut flap that is attached to the Velcro surfaces of the cummerbund. Thanks to the MOLLE flap, the entire area on the back can be used.

The Kummerbund Skeletor consists of a three-row belt strap to which Molle bags can be attached. At the front of the cummerbund there is a Molle panel made of Cordura with a slide-in compartment. The inside of the compartment is covered with Velcro and can hold knives and similar items of equipment, for example.

With the plate carrier Vulcan LC you get a highly modular system that is looking for its equal in terms of protection and modularity.